Que Es Tune Up En Un Carro

What is the need for complete setup? 3

I want to make one for my car, so I want to make it, I don't know what it takes to tune it

I need to reduce engine oil, if using synthetic oil is more expensive, it lasts longer, we still use spark plugs, spark plug cables, air filters, oil filters, gasoline filters, distribution Butter caps and routers, which are on the cap. Check out all the cassettes if you think. You are more than two years old, it also burns, if it is automatic you need to reduce the oil of the gear box if it is standard, just check if it is in the clutch, check the brake lining, Check the brake fluid level, check the air tires. Check the anti-freeze, oil direction in the radiator and I think that's it, good luck toro mechanico.

Oil, air, spark plug wires come out of the spark plug. Wash cards or nuts. Spark plug camouflage .. injector washer .. and gas filter camouflage depends on the car, some of which are smeared in the gas tank with gasoline ... and not good quality clean oil .. Consider

Que Es Tune Up En Un Carro

Complete repairs include washing and lowering the engine, cam filter (air, gasoline, oil), oil cam, PVC valve, disassembling and cleaning of injectors, either manually, with float or by ultrasound. Through, checking antifreeze level, brake fluid, steering and gear cleaning fluid and if necessary I refill, visual inspection of taps, hoses, gaskets and gaskets to make sure everything is minted. Is in the state of, or if bad, cover. Depending on the mileage, you will need a spark plug, EGR valve, distributor tape and old tape (this is done with some special adjustments).
Adjustments should be made every 10,000 km or 6 months, whichever comes first, and oil camouflage should be made every 3 months or 5,000 km on pistons, valves and rings.
For oil camouflage you will need:
An oil stove to lift the car, a wrench to remove the oil filter, a spinner, a tray with a capacity of about 5 liters, protective glasses, nitrile or latex gloves (using can cause skin cancer), A filter and about 5 liters of water.
Lift the car onto the slope, open the hood and open the oil cap, plow under the car, find the crank case, remove the drain cover from the spinner, insert the casing and wait for the oil to come out as soon as the crank case is empty. Remove the oil filter with a special wrench and a little more oil will come out. Insert the litter, lower the vehicle down the slope, measure the oil from the ■■■■■■■■ and add the essential oil to fill it, keep checking so that it does not exceed the limit. Used oil can be disposed of at a parts store or repair shop according to the recycling guidelines. Don't waste it in the gutter.
For Siegel spark plugs, you will need plug sockets and burners (most recommended) or lead wrench or spark plug wrench (and extension if necessary), spark plug (if you have electrodes, you Will need one). A heater On the other hand, secure internet.
The negative battery terminal is removed, the spark plug wire is removed, properly connected (fire control), the spark plug is removed, the spark plug is calibrated to the recommended height of the assembler Goes, or, if not, according to the pre-heated surface (all must be of the same grade, by putting the candle under the candle maker's recommended pressure (if you have a flashlight), if your If you do not have a flashlight, tighten it firmly (remember, they will withstand the impact of the ■■■■.) Without too much exaggeration or tightening as it can damage the spark plug wires or worse. , Spark plug set, keep the cable the same (respect burn order) and that's it.
Going to a garage for the first time and asking for help is a bit difficult for you to get tested so that you can learn to avoid costly mistakes and do it yourself in the blink of an eye.
PS Never wear bracelets, watches, keys or loose clothing or loose or loose sleeves as this can cause accidents. Filters, oils and spark plugs should be of minimum size and meet the specifications recommended by the car manufacturer.
Head spark plug, spark plug (ignition), rotor cover (if distributor), rotor, oil camouflage, oil filter, PCV valve, fuel filter, are important items during adjustment.
What they say in the other answers, insert the injector, adjust and close the valves, a professional should do it Which car do you have and they will give you what you need. Or you need to change the packaging, remember, if you don't know how to dream about balbola, do it.