Pw80 Oil Injector Bypass
On Yamaha Pw80 Dirtke, can you avoid oil injection by mixing oil? 3
The reason I say this is because I don't trust the oil injection if it goes out or your SOL stops working !!
Yes you can, but if you hold the injector, you will have difficulty driving. You may want to remove it or move the oil line to the inlet. Then attach by needle. Above all, it will probably prevent it from breaking and breaking.
Yamaha PW80 oil injection.
Yes, but you should also remove the device from the pump so that it does not get damaged by drying. It also gives you a little more power because you don't have to run the pump. You also need to increase the size of your mainstream a bit. Now that the oil is mixed, there is some oil and some oil will come out of the nozzle. Some early Suzukis had main bearings and oil thrust rods. They may work well with premixes, but I'm a little worried because they're designed to be lubricated directly. If you are driving your Kee on roads and hills, I do not recommend shutting down the oil pump completely. With an oil pump, the engine always receives the right amount of oil. The only way to get oil from the pump is to squeeze the gas. If you are going down under compression or if you release the throttle too fast, no oil will be supplied to the engine. Not just oil, but no oil on the engine because it cleans everything. Oil injection is good and is preferred for pre-mix in all gas flow conditions except MX.
If you stop adding oil to the injection system, the oil injection pump will burn out. If you do not want to inject oil, remove the gear at the end of the oil injection pump to prevent the pump from turning. So you just mix the oil with the gas.
I've never worked on PW 80 before so I don't know if the injection pump is installed. I've worked on a lot of oil Yamahas like Yamaha GT 80, DT 100, DT 175 and many more. Each Yamaha I have worked on has an injection pump in the clutch housing. Remove the clutch cover, but let the injection pump bolt to the clutch cover. In the clutch housing, where the injection pump is screwed, there is a nylon gear. Remove this item.
