Payne Furnace Code 31

Payne rnace srt loop error code 31. It lasts for 5 minutes and then goes out. Try again and do the same. And is still ■■■■. 3

The mother is only 2 years old. The air conditioning worked well all summer and the heater worked last year. We had this problem while heating. We have a nest thermostat.

It will work for about 5 minutes. Turn it off and try again, let it run for 5 minutes, then turn it off and enter the status code 31. I had to turn the device off and on again to turn it on again. The things I tried ... I connected the common wires to the thermostat, blew the inlet pipe and the exhaust pipe with SP vacuum. We found the tail pipe sinking, so we caught it on the roof in the way of the well (when we did that the water flowed from the well and the water pump turned on), the siphon was cleaned and of course. Many times there is no obstruction, the pressure ■■■■■■■ is removed and the rubber hose is checked (no leaks), the fire sensor is cleaned with sandpaper. Click ■■■■ and Ed and both.

What I saw was that when I turned on the inductor I heard a faint sound of water.

If I unplug the red wire and turn on the machine, it will last longer, this is a bug.

update

the answer:

So, I can finally bring technology to market. He said that drinking is a well-known problem of single stage racing. Solution ... bypass the low pressure switch, but bypass the high pressure switch. This solves the problem. And I didn't spend a penny (because it's still under warranty).

Type of drink

The exhaust does not reach the chimney, it is a HE engine, so it leaves the use side. There is no limit, I can say that I run Spvac mode on this tube and the air coming out of the tube is unlimited at the other end.

The filter is new and I also ran the command with the filter and did the same.

@ Mir Sepines

Yeah Al that sounds pretty crap to me, Looks like BT aint for me either. There is a bug in it. I did this last week. I did it today and I'm sure it's still clear. There was water and she got out and went into the swamp.

The sound of water is a sign. Make sure your condensate line is clean. Water can block the pressure switch and cause the radiator to think there is a problem with the exhaust pressure.